Hi,
ich wollte gerade anfangen mir ein Monitorkabel für meinen BBC Micro zu löten, als ich sozusagen über einen Pin in der Belegung beim Micro gestolpert bin. Der Micro soll an einem 1084s mit 9 Pol SubD RGB Buchse betrieben werden.
Der einzige Pol für den ich keinen Gegenpol am 1084s finde ist der 5V Pol, also der mittlere Pol in der DIN Buchse.
Weiß einer Rat?
Grüße
Jörg
1084 & 1084S Monitor Analog Connector
6 PIN DIN FEMALE viewed at the monitor
_______ Pin# Signal
/ 3 \ Pin 1 G Green
/ 2 4 \ Pin 2 HSYNC Horizontal Sync
| 6 | Pin 3 GND Ground
\ 1 _ 5 / Pin 4 R Red
\__/ \__/ Pin 5 B Blue
Pin 6 VSYNC Vertical Sync
1084 & 1084S Monitor Digital Connector
8 PIN DIN 'C' FEMALE viewed at the monitor
_______ Pin# Signal
/ 2 \ Pin 1 NC not connected
/ 4 5 \ Pin 2 R Red
| 1 8 3 | Pin 3 G Green
\ 6 _ 7 / Pin 4 B Blue
\__/ \__/ Pin 5 I Intensity
Pin 6 GND Ground
Pin 7 HSYNC Horizontal Sync
Pin 8 VSYNC Vertical Sync
Commodore 1084d & 1084dS Analog/Digital Connector
9 PIN D-SUB FEMALE viewed at the monitor
_____________
\ 5 4 3 2 1 /
\_9_8_7_6_/
Pin Name Analog Mode Digital Mode
1 GND Ground Ground
2 GND Ground Ground
3 R Red Red
4 G Green Green
5 B Blue Blue
6 I not used Intensity
7 CSYNC Composite Sync not used
8 HSYNC not used Horizontal Sync
9 VSYNC not used Vertical Sync
Read more: http://stason.org/TULARC/pc/ap…Ugd81_HeySN#ixzz2bf3qLhlC