Hi,
unter https://archive.org/details/elektor_computing_3 findet sich die Beschreibung des EC-68-Computers. Hat jemand Dumps der ESS-540 und ESS-541 - EPROMS (sind wohl Varianten des Assist-09-Monitors).
Grüße
Holger
Hi,
unter https://archive.org/details/elektor_computing_3 findet sich die Beschreibung des EC-68-Computers. Hat jemand Dumps der ESS-540 und ESS-541 - EPROMS (sind wohl Varianten des Assist-09-Monitors).
Grüße
Holger
Hallo Holger, hast Du etwas gefunden? Ich habe so einen SBC bekommen mit einer CNC Software drauf und suche ebenfalls die original Firmware. Wäre nett wenn Du mir Bescheid geben könntest.
Danke.
lg. Robert
Sorry, bislang kein weißer Rauch.
Danke für die Info. Ich habe gerade gesehen dass Du ec-68 geschrieben hast und nicht ec-68k.
Das ist der 6800 basierte SBC oder?
lg. Robert
Here they are.
I test it on my EC-6809 and they works.
Depending of the monitor you use (lcd are timing sensitive) you will have to adjust the MC6845 parameters starting at $310 in ESS540.
I always hope to find the original Flex floppy made for this computer. I found they was sell by a german company owned by Werner Schorstein and located at Darmstadt. May be he has archive ? If someone has a track...
For a new Flex adaptation a disassembly of ESS540 seems to be required. ESS541 is ASSIST09 with very few to no modification...
Gerbers of the boards (cpu, fdc + video, bus with reset addon) are freely available. Just ask.
Philippe
Hello,
I put here everything I have about this computer.
Regards.
Philippe
Good finds and work!
I will add it to my website in the Elektor section.
Elektor EC-68 – Retro Computing (hansotten.nl)
(cleaned up) scans of the German, Dutch and French articles. The German and Dutch come from the Elektor Computing 3 and have differences to the French article from Elektor 1986.